Kia Forte: Drive Belt Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Timing System / Drive Belt Installation

1.

Install the drive belt.

(1)	Install the drive belt (C).

(2)

Adjust the tension by turning the tension adjusting bolt (B) clockwise.

Belt tension

New belt:

637.4 ~ 735.5 N (65 ~ 75 kgf, 143.3 ~ 165.3 lbf)

Used belt:

441.3 ~ 539.4 N (45 ~ 55 kgf, 99.2 ~ 121.3 lbf)

(3)

Tighten the alternator mounting bolts (A) with the specified torque.

Tightening torque

M10 bolt:

29.4 ~ 41.2 N.m (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 Ib-ft)

M8 bolt:

21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 15.9 ~ 23.9 Ib-ft)

Drive Belt Inspection

1. Check belt for maintenance and abnormal wear of V-ribbed part. Replace if necessary. ...

Drive Belt Tensioner Components

1. Alternator brace 2. Adjust nut ...

See also:

In-car Sensor (DATC only) Inspection
1. Turn the ignition switch ON. 2. Blow air with changing temperature into the in-car sensor air inlet. Measure the sensor resistance betwe ...

General
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Climate control system
є 1. Fan speed control knob 2. Mode selection knob 3. Temperature control knob 4. Air conditioning button 5. Air intake control button 6. Rear window defroster button Heating and air conditi ...

Categories

Copyright � www.kifomanual.com 2014-2026