Kia Optima Manuals

Kia Forte: In-car Sensor (DATC only) Inspection - Air Conditioning System - Heating,Ventilation, Air Conditioning - Kia Forte TD 2014-2018 Service ManualKia Forte: In-car Sensor (DATC only) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / In-car Sensor (DATC only) Inspection

1.
Turn the ignition switch ON.
2.
Blow air with changing temperature into the in-car sensor air inlet. Measure the sensor resistance between 1 and 2 terminals.

Specification
Temperature [°C(°F)]
 Resistance between terminals 1 and 2 (kΩ)
-30(-22)
 509.6
-15(5)
 216.0
0 (32)
 97.71
15(59)
 47.13
25(77)
 30.00
35(95)
 19.59
50(122)
 10.81
60(140)
 7.463

  
An in-car sensor is a negative type thermistor. The resistance will rise with lower temperature, and reduce with higher temperature.
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance ...

In-car Sensor (DATC only) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel. (Refer to Body - "Center Fascia Panel") ...

See also:

Transaxle Oil Temperature Sensor Circuit Diagram
...

Basic Troubleshooting
Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at hig ...

IMS module Removal
1. Remove the negative (-) battery terminal. 2. Remove the driver seat in the car. (Refer to Body - "Front Seat Assembly") ...

Categories

Copyright www.kifomanual.com 2014-2026