1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
|
3. |
Remove the shower duct (A).
|
4. |
Disconnect the stop lamp switch connector (A).
|
5. |
Remove the brake pedal member mounting bolt (A).
|
6. |
Remove the snap pin (A) and clevis pin (B).
|
7. |
Remove the brake pedal member assembly mounting nuts (A) and then
remove the brake pedal assembly.
|
Engine Oil Inspection
1.
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
Inpection
1.
Measure a resistance of NTC and Heated pad.
A.
NTC resistance - 10.0 kΩ ± 10% (25°C)
B.
H ...