Kia Forte: Brake Pedal

Installation

1. Install in the reverse order of removal.    Use a new washer (A) whenever ...

Removal

1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - & ...

See also:

Accelerator Position Sensor (APS) Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output volt ...

Side Impact Sensor (SIS)
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

Variable Charge Motion Actuator (VCMA) Inspection
1. Turn ignition switch OFF. 2. Disconnect the VCMA connector. 3. Check that the VCMA is not stuck by foreign ...