1. |
Install in the reverse order of removal.
|
2. |
After installation, bleed the brake system.
(Refer to Brake system bleeding)
|
3. |
Check the spilled brake oil.
|
Hood switch Inspection
1.
Disconnect the hood switch connector (A).
2.
Check for continuity between terminals
...
Overhead Console Lamp Inspection
1.
Remove the overhead console lamp assembly then check for continuity
between terminals. If the continuity is not as specified, replace the
map lamp switch.
...
Rear Combination Lamp Removal
Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination lamp cover (A).
...