Kia Forte: Parking Brake Cable Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Parking Brake System / Parking Brake Cable Removal
The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
| 1. |
Remove the floor console assembly.
(Refer to Body - "Floor console")
|
| 2. |
Disconnect the connector (A) of parking brake switch.
|
| 3. |
Remove the parking brake cable (B) after removing the cable retainer
(A).
|
| 4. |
Raise the vehicle, and make sure it is securely supported.
|
| 5. |
Remove the rear tire and wheel.
|
| 6. |
Remove the parking brake cable (B), after removing the clip (A).
|
| 7. |
Loosen the parking brake cable bracket bolts and remove the parking
brake cable (A).
|
Parking Brake Lever Adjustment
Parking Brake Lever Stroke Adjustment
1.
Remove the floor console.
(Refer to Body group - "Floor console")
2.
Apply the b ...
Parking Brake Cable Installation
1.
Install the parking brake cable (A).
Tightening torque :
8.8 ~ 14.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
...
See also:
Accelerator Position Sensor (APS) Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine ...
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...
Oil Pump Unit (OPU) Removal
1.
Remove the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - “Crash Pad”)
...
Copyright © www.kifomanual.com 2014-2025