Kia Forte: Removal
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Pull the passenger seat towards the front till the end.
|
| 3. |
Disconnect the yaw rate & lateral G sensor connector (A).
|
| 4. |
Remove the mounting bolts (B).
|
| 5. |
Install in the reverse order of removal.
|
Yaw-rate and Lateral G Sensor
When the vehicle is turning with respect to a vertical axis the yaw rate
sensor detects the yaw rate electronically by the vibration change of plate
fork inside the yaw rate sensor.
If ya ...
G-Sensor Calibration
1.
Ignition "OFF", connect GDS.
2.
Ignition "ON" & Engine "OFF" select vehicle name and ESC system.
...
See also:
Camshaft Position Sensor (CMPS) Description
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft
position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and detects the piston
pos ...
Special Service Tools
Tool (Number and name)
Illustration
Use
09977-3R000
Disc & hub assembly bolt remover
Removal and installation of disc & hub assembly ...
Telemetics Unit (TMU) Component
Connector Pin Specification
No.
Pin Name
Type
From
To
Description (Wiring
Spec.)
1
GND
DC Ground
TMU
Batt ...
Copyright © www.kifomanual.com 2014-2025