Kia Optima Manuals

Kia Forte: Glove Box Housing  Replacement - Crash Pad - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Glove Box Housing  Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing  Replacement

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Disconnect the stopper (B) from the glove box (A).
2.
Disconnect the air damper (A) from the glove box (B).
3.
Disconnect the pins (A) and then remove the glove box (B).
4.
Using a screwdriver or remover, remove the crash pad side cover [RH] (A).
5.
Remove the glove box hose cover (A).
6.
Remove the glove box hose (B) by sliding it upward.
7.
After loosening the mounting screws, then remove the glove box housing (A).
8.
Disconnect the glove box lamp connector (A).
9.
Installation is the reverse of removal.
  
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.
Glove Box Housing  Component Location
1. Glove box housing ...

Steering Column Shroud Panel Component Location
1. Steering column shroud lower panel 2. Steering column shroud upper panel ...

See also:

Front Door Module  Component Location
(4Door, 5Door) 1. Front door module (2Door) 1. Front door module ...

Engine Cover Removal and Installation
1. Remove the engine cover (A).    • ...

Windshield Wiper-Washer Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to Steering System - "Steering Wheel") ...

Categories

Copyright www.kifomanual.com 2014-2026