The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Depress the flasher switch with the ignition switch in any position. The flasher switch is located in the center console switch panel. All turn signal lights will flash simultaneously.
Component Location
1. Audio unit
2. Tweeter speaker
3. Antenna cable connector
4. Glass antenna amplifier (Radio)
5. Front door speaker
6. Rear door speaker
7. Antenna feeder cable
8. ...
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect ignitio ...
Start/Stop Button Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center garnish [LH]
(A).
...