Kia Forte: Installation - Multifunction Switch - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Multifunction Switch / Installation

1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steering column upper and lower shrouds.
4.
Install the steering wheel.
  
Make sure the multifunction switch connectors are plugged in properly.
Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to Steering System - "Steering Wheel") ...

Horn
...

See also:

Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the battery (A) and ECM (B). ...

Checking the brake/clutch  fluid level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and adding brake/clutch* ...

General Inspection
After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symp ...

Copyright © www.kifomanual.com 2014-2025