Kia Forte: Overhead Console Lamp Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp Inspection
| 1. |
Remove the overhead console lamp assembly then check for continuity
between terminals. If the continuity is not as specified, replace the
map lamp switch.
|
Room Lamp Installation
Room Lamp
1.
Reconnect the connector.
2.
Install the room lamp assembly.
3.
Install the lens.
...
Overhead Console Lamp Removal
1.
Disconnect the negative (-) battery terminal.
2.
Loosen 2 screws holding the overhead console (A).
3.
...
See also:
Auto Defogging Sensor Description
The auto defogging sensor is installed on the front windshield glass.
The auto defogging sensorr senses moisture on the windshild. The air conditioner
control module receives the signal from ...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Pull the passenger seat towards the front till the end.
...
Brake Booster Vacuum Pressure Sensor Inspection
1.
Check installation status of BBVPS and Vacuum hose or damage of
vacuum hose.
2.
Connect GDS to DLC (Data Link Cable).
...
Copyright © www.kifomanual.com 2014-2024