Kia Forte: Overhead Console Lamp Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Loosen 2 screws holding the overhead console (A).
|
| 3. |
Disconnect the connectors (A) of sunroof switch and lamp switch
then remove the overhead console lamp assembly.
|
| 4. |
If necessary to replace the bulb, replace the bulb after disconnecting
the connectors.
|
Overhead Console Lamp Inspection
1.
Remove the overhead console lamp assembly then check for continuity
between terminals. If the continuity is not as specified, replace the
map lamp switch.
...
Overhead Console Lamp Installation
1.
Install the overhead console lamp after connecting the sunroof
switch connector and lamp connector.
2.
Install the lens after tightening ...
See also:
Heated Oxygen Sensor (HO2S) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S termi ...
ECM Terminal And Input/Output signal (M/T)
ECM Terminal Function
Connector [CNG-MA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #1) control output
Ignition Co ...
CVVT (Continuously Variable Valve Timing) System Description
Continuous Variable Valve Timing (CVVT) system advances or retards the
valve timing of the intake and exhaust valve in accordance with the ECM control
signal which is calculated by the engine ...
Copyright © www.kifomanual.com 2014-2025