1. |
Ignition "ON".
|
2. |
Turn on the head lamp switch.
|
3. |
Check for operation. If the aim of the head lamps changes smoothly
when the head lamp leveling switch is turned.
|
4. |
If the operation does not work well, inspect the connector and
terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary,
and recheck the system.
If the terminals look OK, go to step 5.
|
5. |
Substitute with a known-good head lamp assembly and check for
proper operation.
|
Cooling Fan Inspection
Fan Motor
1.
Disconnect the fan motor connector from the resistor.
2.
Connect the battery voltage to the "+" terminal and ...
Removal
1.
Remove the transaxle assembly.
(Refer to Manual Transaxle System - " Manual Transaxle")
2.
Remove the clutch release beari ...
Adjustment
Stop lamp switch clearance adjustment
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~
0.08in), conform to below.
1.
Disconnect the s ...