Kia Forte: Evaporator Temperature Sensor Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / Evaporator Temperature Sensor Inspection
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect evaporator temperature sensor.
|
| 3. |
Using the multi-tester, measure resistance between terminal "1"
and "2" of the evaporator temperature sensor.
|
| 4. |
Connect the evaporator temperature sensor connector.
|
| 5. |
Run the engine and turn the A/C switch ON, then measure the voltage
between the terminals of the harness connector.
Specification
|
Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature
and interrupt compressor relay power in order to prevent evaporator freezing
by excessive cooling.
...
Evaporator Temperature Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the evaporator temperature sensor connector (A).
3.
...
See also:
Crankshaft Damper Pulley Inspection
Check the crankshaft damper pulley for vibration in rotation, oil dust
deposit of V-ribbed part. Replace if necessary. ...
Door Switch Inspection
1.
Remove the door switch and check for continuity between the terminals.
...
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
Copyright © www.kifomanual.com 2014-2025