Kia Forte: Photo Sensor Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / Photo Sensor Inspection
| 1. |
Turn the ignition switch ON.
|
| 2. |
Connect the GDS.
|
| 3. |
Emit intensive light toward the photo sensor using a lamp, and
check the output voltage change.
|
| 4. |
The voltage will rise with higher intensive light and reduce with
lower intensive light.
|
Photo Sensor Description
The photo sensor is located at the center of the defrost nozzle.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode.
The solar radiation received by its light receiving p ...
Photo Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
With a flat-head screwdriver, remove the photo sensor (A) from
the center of the defros ...
See also:
Rear Shock Absorber Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure
it is securely supported.
2.
Remove the front wheel and tire (A) from f ...
Specification
Item
Description
Power source
3V
Operating temperature
-20°C ~ +60°C (-4°F ~ 140°F)
RF Modulation
FSK
LF Modulati ...
Antenna Coil Installation
1.
Install the antenna coil.
2.
Connect the antenna coil connector.
3.
Install the crash pad lower panel.
...
Copyright © www.kifomanual.com 2014-2025