Kia Forte: Blower Resistor Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Resistor Inspection
| 1. |
Measure terminal-to-terminal resistance of the blower resistor.
|
| 2. |
If the measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Power Mosfet Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the power mosfet connector (A) and then remove the
power mosfet (B) after lo ...
Blower Resistor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the blower resistor connector (A) and then remove the
blower resistor (B) af ...
See also:
AGM Battery Specification
Item
Specification
Model type
AGM 70L-DIN
Capa ticy [20HR / 5HR] (AH)
70/56
Cold Cranking Amperage (A)
760 (SAE) / 610 (EN)
...
Accelerator Position Sensor (APS) Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine ...
Copyright © www.kifomanual.com 2014-2025