Kia Forte: Rear Oil Seal Installation - Cylinder Block - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Oil Seal Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Installation

1.
Install a new rear oil seal.
(1)
Apply engine oil on the edge of new oil seal.
(2)
Using SST (09231-H1100, 09214-2E000) and a hammer, tap in the oil seal (A) until the SST face is aligned with the cylinder block assembly rear face.

2.
Install the other parts reverse order of removal.
Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") Remove the manual transaxle. (Refer to Manual ...

Piston and Connecting Rod Components
1. Piston ring 2. Snap ring 3. Piston pin 4. Piston 5. Connecting rod 6. Connecting rod upper bearing 7. Connecting rod lower bearing 8. Connecting rod bearing cap ...

See also:

IMS module Removal
1. Remove the negative (-) battery terminal. 2. Remove the driver seat in the car. (Refer to Body - "Front Seat Assembly") ...

Air Ventilation Seat Unit Components Location
Components Location (1) 1. Seat back blower 2. Seat cushion blower 3. Air ventilation unit 4. Air ventilation switch Components Location (2) Components Locati ...

AGM Battery Inspection
Battery Diagnostic Flow Vehicle parasitic current inspection 1. Turn all the electric devices OFF, and then turn the ignition switch OFF. ...

Copyright www.kifomanual.com 2014-2026