1. |
Remove the cooling fan (A) from the cooling fan assembly.
|
2. |
Disconnect the fan motor connector (A) from the resistor.
|
3. |
Loosen the screws and then remove the fan motor (A) from the cooling
fan shroud.
|
4. |
Assemble in the reverse order of disassembly.
|
Specifications
Item
Specification
Master cylinder
Type
Fixed seal
Cylinder I.D.
22.22 mm
Piston stroke
45 ± 1 mm (1.77 ± 0.039 in)
...
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect ignitio ...
Removal
1.
Drain the brake fluid through the bleed plug (A).
•
...