Kia Forte: Oil Pressure Switch Removal and Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Removal and Installation
| 1. |
Disconnect the oil pressure switch connector (A) and then remove
the oil pressure switch (B).
|
| 2. |
Install in the reverse order of removal.
|
When installing the oil pressure switch, apply seal lock to the
thread.
|
Seal lock : THREEBOND 2403
Thickness : 0.2 ~ 0.4 mm
(0.008 ~ 0.016 in.)
|
Oil Pump Inspection
1.
Remove the relief plunger.
Remove the plug (A), spring (B) and relief plunger (C).
Tightening torque
Plug (A) :
...
Oil Pressure Switch Inspection
1.
Check the continuity between the terminal and the body with an
ohmmeter.
If there is no continuity, replace the oil pressure switch.
...
See also:
Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme
caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs ar ...
Fuel Tank Pressure Sensor (FTPS) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the rear seat.
(Refer to Body - “Rear Se ...
Shift Lever Inspection
1.
Check operating of lever of T/M side when operating shift lever
after assembly.
2.
When shift lever to "R" position, check th ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026