Kia Forte: Interior
| Interior A |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior B |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior C |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior D |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø6.6) |
Cowl crossbar mounting hole (Ø9) |
|
|
|
|
| Front door checker mounting hole (Ø13) |
Cowl side trim mounting hole (Ø8.5) |
Curtain airbag mounting hole (Ø6.6) |
|
|
|
|
| Seat belt height adjuster upper mounting hole (Ø16) |
Seat belt height adjuster lower mounting hole (Ø16) |
Rear door checker mounting hole (Ø13) |
|
|
|
|
| Seat belt retractor mounting hole (Ø12.5) |
Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø6.6) |
|
|
|
|
| Curtain airbag mounting hole (Ø8) |
Curtain airbag mounting hole (Ø6.6) |
Wheel house mounting hole (Ø8.5) |
|
|
|
|
| Rear door striker mounting hole (Ø13) |
Wheel house mounting hole (Ø8) |
Parking brake lever mounting hole (Ø9) |
|
|
|
|
| Floor wiring harness mounting hole (12X7) |
Front seat mounting hole (Ø13) |
Floor wiring harness mounting hole (12X7) |
|
|
|
|
| Floor wiring harness mounting hole (12X7) |
Rear floor panel tooling hole (12X7) |
Rear seat mounting hole (Ø16) |
|
|
|
|
| Rear floor panel tooling hole (Ø6.6) |
Rear transverse trim mounting hole (Ø8.5) |
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
See also:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
...
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available.
However, use washer solvent with antifreeze characterist ...
Variable Charge Motion Actuator (VCMA) Description
The Variable Charge Motion Actuator (VCMA) is installed on the inlet of
the intake manifold.
It consists of a DC motor which actuates the VCM valve and a position
sensor which detects th ...