Kia Forte: DC/DC Converter Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Charging System / DC/DC Converter Removal
| 1. |
Disconnect the battery negative (-) cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - Crash pad lower panel.)
|
| 3. |
Disconnect the DC/DC converter connector (A).
|
| 4. |
Remove the DC/DC converter (A).
|
DC/DC Converter Circuit Diagram
In the ISG mode, if the power of an audio system turnsOFF by drawdown
while “Auto Starting” or “Idle Starting”functi ...
DC/DC Converter Installation
1.
Install in the reverse order of removal.
If the battery negative (-) c ...
See also:
Component Location
Component Location (1)
1. Smart key unit
2. External buzzer
3. Door outside handle
4. Interior antenna
5. RF receiver
Component Location (2)
1. Bump ...
Specification
Tightening Torques
Item
N.m
kgf.m
lb-ft
Passenger Airbag (PAB)
8.0 ~ 9.0
0.82 ~ 0.92
5.9 ~ 6.7
Curtain Airbag (CAB)
...
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Copyright © www.kifomanual.com 2014-2025