Kia Forte: Engine Control Module (ECM) Removal
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer System")
|
When replacing the ECM, the vehicle equipped with the smart key
system (Button start) must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the ECM learns the smart key information
automatically.
|
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the ECM Connector (A).
|
| 3. |
Remove the battery. (Refer to Engine Electrical System - "Battery")
|
| 4. |
Remove the mounting bolts (A) and then remove the ECM (B).
|
Engine Control Module (ECM) Circuit Diagram
Engine Control Module (ECM) InstallationResetting The Sunroof
Whenever the vehicle battery is disconnected or discharged, or you use
the emergency handle to operate the sunroof, you have to reset your sunroof
system as follows :
1.
...
Components
1. Slide motor
2. Height motor
3. Recline motor
4. Power seat control switch
5. Recline control switch
6. Lumbar support switch
7. Lumbar support motor
8. Tilt moto ...
Power brakes
Your vehicle has power-assisted brakes that adjust automatically through normal
usage.
In the event that the power-assisted brakes lose power because of a stalled engine
or some other reason, you c ...