Kia Forte: Steering Column and Shaft Disassembly
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Steering System / Electric Power Steering / Steering Column and Shaft Disassembly
Universal joint assembly
| 1. |
Loosen the bolt (A) and then disconnect the universal joint assembly
from the steering column assembly.
|
| 2. |
Reassembly is the reverse of the disassembly.
|
Key lock assembly
| 1. |
Make a groove on the head of special bolts (A) by a punch.
|
| 2. |
Loosen the special bolt using a screw driver and then remove the
key lock assembly from the steering column assembly.
|
| 3. |
Reassembly is the reverse of the disassembly.
|
Steering Column and Shaft Replacement
1.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
2.
Remove the steering column shroud.
(Ref ...
Steering Column and Shaft Inspection
1.
Check the steering column for damage and deformation.
2.
Check the joint bearing for damage and wear.
3.
Che ...
See also:
Using the usb device
To use an external USB device, make sure the device is not connected when
starting up the vehicle. Connect the device after starting up.
If you start the engine when the USB device is connected ...
Cruise Control Switch Component Location
1. Remote control switch(LH)
2. Remote control switch(RH)
3. Bluetooth hands free switch
4. Trip switch
...
Multimedia Jack Installation
1.
Install the multimedia jack.
2.
Connect the multimedia jack connector.
3.
Install the floor console assembly ...
Copyright © www.kifomanual.com 2014-2025