Kia Forte: Manifold Absolute Pressure Sensor (MAPS) Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the manifold absolute pressure sensor connector (A).

3.	Remove the installation bolt (B), and then remove the sensor from the surge tank.

Manifold Absolute Pressure Sensor (MAPS) Inspection

1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Conditio ...

Manifold Absolute Pressure Sensor (MAPS) Installation

• Install the component with the specified torques. • ...

See also:

SS-A Solenoid Valve(ON/OFF) Circuit Diagram
...

Purge Control Solenoid Valve (PCSV) Inspection
1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

Inspection
• Frequent inhalation of brake pad dust, regardless of material composition, could be ...

Categories

Copyright � www.kifomanual.com 2014-2026