Kia Forte: Engine Coolant Temperature Sensor (ECTS) Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the engine coolant temperature sensor connector (A).

3.

Remove the sensor (B).

Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.

4.	Supplement the engine coolant (Refer to “Cooling System” in EM group).

Engine Coolant Temperature Sensor (ECTS) Inspection

1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS. 4. ...

Engine Coolant Temperature Sensor (ECTS) Installation

• Install the component with the specified torques. • ...

See also:

Windows
(1) Driver’s door power window switch (2) Front passenger’s door power window switch (3) Rear door (left) power window switch (4) Rear door (right) power window switch (5) Window opening and c ...

System Block Diagram
...

Front Hub / Knuckle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Categories

Copyright © www.kifomanual.com 2014-2025