Kia Forte: Camshaft Position Sensor (CMPS) Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Apply the engine oil to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage when installation.
|
|
| •
|
Be careful not to damage the sensor housing and the connector.
|
| •
|
Be careful not to damage the O-ring.
|
|
|
1. |
Install in the reverse order of removal.
Camshaft position sensor installation
bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
•
DON’T remove the camshaft position sensor during engine
running or right after eng ...
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knocking.
Whe ...
See also:
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Description
Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine
modifications and the addition of special control components.
Modifications to the combustion chamber, intake manifo ...
Door Switch Inspection
1.
Remove the door switch and check for continuity between the terminals.
...
Camshaft Position Sensor (CMPS) Removal
Knock Sensor (KS) Description