Kia Forte: Heated Oxygen Sensor (HO2S) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Removal
| [SULEV] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the connector (A), and then remove the sensor (B).
[Bank 1 / Sensor 1]
[Bank 1 / Sensor 2]
|
| [LEV2] |
[Bank 1 / Sensor 1]
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the connector (A), and then remove the sensor (B).
|
[Bank 1 / Sensor 2]
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the console side cover (A).
|
| 3. |
Disconnect the connector (A), and then remove the sensor (B).
|
Heated Oxygen Sensor (HO2S) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S termi ...
Heated Oxygen Sensor (HO2S) Installation
•
Install the component with the specified torques.
•
...
See also:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater & A/C control unit.
(Refer to Heating,Ventilation, Air Conditi ...
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...
Component Location
[Engine Room]
1. Receiver Drier
2. Condenser
3. Ambient Temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Servic ...
Copyright © www.kifomanual.com 2014-2025