Kia Forte: Purge Control Solenoid Valve (PCSV) Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the purge control solenoid valve connector (A).

3.	Disconnect the vapor hoses (B) from the purge control solenoid valve.

4.	Remove the valve (C) from the surge tank after pulling it.

Purge Control Solenoid Valve (PCSV) Inspection

1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

Purge Control Solenoid Valve (PCSV) Installation

• Install the component with the specified torques. • ...

See also:

Front Seat Frame Assembly Component Location
1. Front seat back frame assembly 2. Front seat cushion frame assembly ...

Troubleshooting
Symptom Suspect Area Remedy (Refer to page) Water leaks from sunroof Dirt accumulated in drain tube Clear dirt inside of drain Clogged drai ...

Shift Cable Components
1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

Categories

Copyright � www.kifomanual.com 2014-2026