Kia Forte: DC/DC Converter Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / DC/DC Converter Removal
| 1. |
Disconnect the battery negative (-) cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - Crash pad lower panel.)
|
| 3. |
Disconnect the DC/DC converter connector (A).
|
| 4. |
Remove the DC/DC converter (A).
|
DC/DC Converter Circuit Diagram
In the ISG mode, if the power of an audio system turnsOFF by drawdown
while “Auto Starting” or “Idle Starting”functi ...
DC/DC Converter Installation
1.
Install in the reverse order of removal.
If the battery negative (-) c ...
See also:
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cov ...
Door Scuff Trim Component Location
(4Door, 5Door)
1. Front door scuff trim
2. Rear door scuff trim
(2Door)
1. Front door scuff trim
...
Tightening Torques
Items
N.m
kgf.m
lb-ft
Oil drain plug
58.9 ~ 78.5
6.0 ~ 8.0
43.4 ~ 57.8
Oil filler plug
58.9 ~ 78.5
6.0 ~ 8.0
...
Copyright © www.kifomanual.com 2014-2025