Kia Optima Manuals

Kia Forte: Alternator On-vehicle Inpection - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Alternator On-vehicle Inpection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Alternator On-vehicle Inpection

  
•
Check that the battery cables are connected to the correct terminals.
•
Disconnect the battery cables when the battery is given a quick charge.
•
Never disconnect the battery while the engine is running.
Check The Battery Terminals And Fuses
1.
Check that the battery terminals are not loose or corroded.
2.
Check the fuses for continuity.
Inspect Drive Belt
1.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
  
Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.

Alternator Specification
Item Specification Rated voltage 13.5V, 120A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in type ...

Alternator Removal
1. Disconnect the battery negative (-) cable. 2. Remove the drive belt. (Refer to Engine Mechanical System - "Timing Chain") ...

See also:

Head Lamp Leveling Actuator Inspection with GDS
Initialization and diagnosis sequence by using GDS equipment. Below content summarize the procedure for A/S using GDS. No. Procedure 1 Locate vehicle to flat ...

Control System Composition
Fault Diagnosis Features a fail-safe mechanism that provides "limp-home" 4th gear hold to enable the vehicle to be driven to the owner's home or dealer shop. Fail-Safe: ...

Brake Booster Vacuum Pressure Sensor Description
In order to ensure adequate brake power assistance in every situation, the brake booster is equipped with a partial vacuum sensor. The brake booster vacuum pressure sensor is located beside t ...

Categories

Copyright www.kifomanual.com 2014-2026