Kia Optima Manuals

Kia Forte: Starter Removal - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Starter Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Starter Removal

1.
Disconnect the battery negative (-) cable.
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Engine And Transaxle Assembly")
3.
Disconnect the starter cable (A) from the B terminal on the solenoid then disconnect the connector (B) from the S terminal.
Tighting torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

4.
Remove the 2 bolts holding the starter, then remove the starter (A).
Tighting torque :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

Starter Description
The starting system includes the battery, starter, solenoid switch, inhibitor switch (A/T), ignition switch, ignition lock switch, connection wires and the battery cable. When the ignitio ...

Starter Installation
1. Install in the reverse of removal. ...

See also:

Troubleshooting
Symptom Suspect Area Remedy (Refer to page) Water leaks from sunroof Dirt accumulated in drain tube Clear dirt inside of drain Clogged drai ...

Battery Sensor Installation
1. Install in the reverse order of removal. Battery sensor cable installation bolt: 10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~10.1 lb-ft) ...

Rear Drum Brake
Components 1. Shoe hold down pin 2. Shoe adjuster 3. Upper return spring 4. Adjusting lever 5. Shoe 6. Adjusting spring 7. Lower return spring 8. Shoe hold spri ...

Categories

Copyright www.kifomanual.com 2014-2026