Kia Forte: Brake Switch Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Switch Removal
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the crash pad lower panel. (Refer to the Body group-"crash
pad")
|
| 3. |
Disconnect the stop lamp switch connector (A).
|
Brake Switch Inspection
1.
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in an ...
Brake Switch Installation
1.
Install in reverse of removal.
...
See also:
Control Cable Inspection
1.
Check the select cable for proper operation and for damage.
2.
Check the shift cable for proper operation and for damage.
...
Troubleshooting Guide
Before Thinking The Product Has Malfunctioned
1.
Errors which occur during the operation or installation of the
device may be mistaken as a malfunction of the actual de ...
Auto Defogging Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the sensor cover (A) and then remove the auto defogging
sensor (B).
...
Copyright © www.kifomanual.com 2014-2025