Kia Forte: Filler-Neck Assembly Installation - Fuel Delivery System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Filler-Neck Assembly Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Installation

1.
Install in the reverse order of removal.

Filler-neck assembly bracket installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-Neck Assembly Removal
1. Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A). 2. Remove the rear-LH wheel, tire, and the i ...

Accelerator Pedal Removal
1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). ...

See also:

Operation
Evaporative System Monitoring Evaporative And ORVR Emission Control System This system consists of a fill vent valve, fuel shut-off valve, fuel cut valve (for roll over), two way val ...

Component Replacement After Deployment
   Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing ...

Components
1. Telematics unit (TMU) 2. Roof Antenna (GPS) 3. AUX jack 4. AVN head unit 5. Mic ...

Copyright www.kifomanual.com 2014-2025