Kia Optima Manuals

Kia Forte: Removal - Clutch Master Cylinder - Clutch System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Master Cylinder / Removal

1.
Separate the push rod (C) after remove the pin (A) and washer (B).
2.
Remove the battery.
(Refer to Engine Electrical System - "Battery")
3.
Remove the ECM.
(Refer to Engine Control/Fuel System - "Engine Control Module (ECM)")
4.
Disconnect the clutch regulator (B) and reservoir hose (A) from the clutch master cylinder.
  
•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

5.
Remove the master cylinder (A) by rotating in a clockwise direction.
Components
1. Reverse hose 2. Master cylinder 3. Ignition lock switch 4. Clutch switch 5. Clutch arm assembly 6. Pedal pad ...

Installation
1. Install in the reverse order of removal. 2. After be equipped, perform bleeding air procedure in clutch release cylinder after pouring ...

See also:

Sirius™  Radio
Using SIRIUSTM Satellite Radio Your Kia vehicle is equipped with a 3 month complimentary period of SIRIUS ™ Satellite Radio so you have access to over 130 channels of music, information, and ente ...

Blower Motor Inspection
1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage does not operate well, substitute ...

Filler-Neck Assembly Removal
1. Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A). 2. Remove the rear-LH wheel, tire, and the i ...

Categories

Copyright � www.kifomanual.com 2014-2026