Kia Optima Manuals

Kia Forte: Valve Body Installation - Hydraulic System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Valve Body Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Hydraulic System / Valve Body Installation

1.
Install in the reverse order of removal.
  
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
  
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
•
Replace the gasket (A) before reinstalling the valve body cover.

Valve Body Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

Clutch & Brake
...

See also:

Fuel Filter Removal
1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) and the fuel sender ...

Heater & A/C Control Unit (Manual) Components
Connector Pin Function Connector No. Description Connector No. Description A 1 Ground B 14 In ...

Fuel Tank Pressure Sensor (FTPS) Circuit Diagram
(M/T) (A/T) ...

Categories

Copyright � www.kifomanual.com 2014-2026