Kia Forte: Input Speed Sensor Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Input Speed Sensor Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Removal

1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
3.
Remove the under cover (A).

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid")
5.
Remove the air breather hose (A).
6.
Remove the valve body cover (B).

Tightening torque:
11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)

  
Remove installation bolts in the engine compartment first and then remove others under the vehicle.

7.
Remove the plate and the detent spring (A) after removing the bolt.

Tightening torque:
11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)

8.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

  
Be careful not to damage the harness lock connector.

9.
Remove the valve body assembly (A).

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

10.
Disconnect the input & output speed sensor connector(A).
11.
Remove the input & output speed sensor (B) after removing the bolts(2ea).

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Input Speed Sensor Installation
1. Installation is the reverse of removal.    After replacement or reinstallation procedure of ...

See also:

Luggage Side Trim Component Location
(5Door) 1. Luggage side trim ...

Inspection
   • Frequent inhalation of brake pad dust, regardless of material composition, could be ha ...

Power Seat Control Switch Installation
1. Connect the connector and install the power seat control switch. 2. Install the seat cover. ...

Copyright © www.kifomanual.com 2014-2024