Kia Forte: Output Speed Sensor Removal

1.	Disconnect the negative (-) battery cable.

2.	Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air cleaner")

Remove the under cover (A).

Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.	Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to Hydraulic System - "Fluid")

5.	Remove the air breather hose (A).

Remove the valve body cover (B).

Tightening torque:

11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)

Remove installation bolts in the engine compartment first and then remove others under the vehicle.

Remove the plate and the detent spring (B) after removing the bolt (A).

Tightening torque:

11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)

Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Be careful not to damage the harness lock connector.

Remove the valve body assembly (A).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

10.	Disconnect the input & output speed sensor connector (A).

11.

Remove the input & output speed sensor (B) after removing the bolts (2ea).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

1. Install in the reverse order of removal. After replacement or reinstal ...

Categories