Kia Optima Manuals

Kia Forte: Output Speed Sensor Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Output Speed Sensor Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor Installation

1.
Install in the reverse order of removal.
  
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Replace the gasket (A) before reinstalling the valve body cover.

Output Speed Sensor Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Description
Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque converter. ...

See also:

Ignition Coil Specification
Item Specification Primary Coil Resistance (Ω) 0.75 ± 15％ [20°C (68°F)] Secondary Coil Resistance (kΩ) 5.9 ± 15％ [20 ...

Temperature Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...

Delivery Pipe Installation
1. Install in the reverse order of removal. Delivery pipe installation bolt: 18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft) ...

Categories

Copyright www.kifomanual.com 2014-2026