Kia Optima Manuals

Kia Forte: Output Speed Sensor Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Output Speed Sensor Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor Installation

1.
Install in the reverse order of removal.
  
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Replace the gasket (A) before reinstalling the valve body cover.

Output Speed Sensor Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Description
Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque converter. ...

See also:

Door Scuff Trim Component Location
(4Door, 5Door) 1. Front door scuff trim 2. Rear door scuff trim (2Door) 1. Front door scuff trim ...

Manifold Absolute Pressure Sensor (MAPS) Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Conditio ...

Replacement
Rear Brake Pads 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft ...

Categories

Copyright www.kifomanual.com 2014-2026