Kia Forte: Front Stabilizer Link Replacement - Front Suspension System - Suspension System - Kia Forte TD 2014-2018 Service ManualKia Forte: Front Stabilizer Link Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / Front Suspension System / Front Stabilizer Link Replacement

1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.

Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

  
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
3.
Remove the stabilizer link (A) loosening the nut (B) and (C).

Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

4.
Installation is the reverse of removal.
5.
Check the front alignment.
(Refer to Front Suspension System - "Front Alignment")
Front Stabilizer Bar Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. ...

Sub Frame Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

See also:

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Starter Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

Troubleshooting
Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises • Worn crankshaft bearings ...

Copyright www.kifomanual.com 2014-2026