Kia Optima Manuals

Kia Forte: Transaxle Oil Temperature Sensor Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Transaxle Oil Temperature Sensor Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Installation

1.
Install in the reverse order of removal.
  
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Replace the gasket (A) before reinstalling the valve body cover.

Transaxle Oil Temperature Sensor Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

Input Speed Sensor Description
Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module(TCM). The sensor provid ...

See also:

Input Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Front Stabilizer Bar Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. ...

Rear Door Side Weatherstrip Replacement
(4Door, 5Door) 1. Loosen the rear door checker (B) mounting bolt. Tightening torque: 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m,12.3 ~ ...

Categories

Copyright www.kifomanual.com 2014-2026