Kia Forte: Transaxle Oil Temperature Sensor Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Removal
| 1. |
Disconnect the negative (-) battery cable.
|
| 2. |
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
| 3. |
Remove the under cover (A).
|
| 4. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid")
|
| 5. |
Remove the air breather hose (A).
|
| 6. |
Remove the valve body cover (B).
|
| 7. |
Disconnect the oil temperature sensor connector (A).
|
| 8. |
Remove the oil temperature sensor (A) after removing a bolt.
|
Transaxle Oil Temperature Sensor Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Transaxle Oil Temperature Sensor Installation
1.
Install in the reverse order of removal.
After replacement or reinstal ...
See also:
Service Standard
Item
Specification
Ignition Timing (°)
BTDC 5 ± 10
Idle Speed (rpm)
A/C OFF
Neutral, N, P-range
640 ± 100
D-range
...
Smart Key Unit Inspection
Smart Key Unit
-
Refer to Smart key System - "Smart key Diagnostic"
Smart Key Switch
-
Refer to Smart key System - "Smart key D ...
Removal
1.
Disconnect the brake fiuid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cylinder rese ...
Copyright © www.kifomanual.com 2014-2025