Kia Optima Manuals

Kia Forte: Installation - Front Impact Sensor (FIS) - SRSCM - Restraint - Kia Forte TD 2014-2018 Service ManualKia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) / Installation

  
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting nut.
Tightening torque :
8.0 ~ 10.0 N.m (0.82 ~ 1.02 kgf.m, 5.9 ~ 7.4 lb-ft)
3.
Connect the front impact sensor connector.
4.
Left side - Install the head lamp assembly.
(Refer to Body electrical - "Head Lamps")
Right side - Install the washer reservoir.
(Refer to Body electrical - "Front washer motor")
5.
Reconnect the battery negative cable.
6.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Removal
   • Removal of the airbag must be performed according to the precautions/ procedures des ...

Side Impact Sensor (SIS)
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

See also:

Body Panel Gaps
...

Hood switch Description
The hood switch is included as the influencing factors in the calculation of the ISG function. If the hood is open, the engine must not be started or stopped by the ISG function for safety re ...

Instrument Cluster Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel. (Refer to Body - "Cluster Fascia Panel") ...

Categories

Copyright � www.kifomanual.com 2014-2026