Kia Optima Manuals

Kia Forte: Removal - Front Impact Sensor (FIS) - SRSCM - Restraint - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) / Removal

  
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Left side - Remove the head lamp assembly.
(Refer to Body electrical - "Head Lamps")
Right side - Remove the washer reservoir.
(Refer to Body electrical - "Front washer motor")
3.
Disconnect the front impact sensor connector (A).
4.
Remove the front impact sensor after loosening the mounting nut (B).
Components
...

Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

See also:

Tightening Torque
Part tightened N.m Kgf.m lbf.ft Condenser - Discharge hose 7.8~11.7 0.8~1.2 5.7~8.6 Condenser - Liquid tube Comp ...

Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the smart junction box (Refer to Body Electri ...

Rear Torsion Beam Axle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

Categories

Copyright www.kifomanual.com 2014-2026