Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Brake Booster / Installation

1.

Install in the reverse order of removal.

A.	Before installing the pin, apply the grease to the joint pin.

B.	Use a new snap pin whenever installing.

2.	After installing, bleed the brake system. (Refer to Brake system bleeding)

3.	After be equipped perform bleeding air procedure in clutch release cylinder after pouring the brake fluid. [MT only] (Refer to Clutch - "Clutch Release Cylinder")

Inspection

1. Inspect the check valve in the vacuum hose. Do not remove the check va ...

Vacuum Pump

Components 1. Vacuum pump 2. Bracket 3. Lead wire assembly ...

See also:

Audio Remote Control Circuit Diagram
...

Accelerator Position Sensor (APS) Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...

Brake Switch Inspection
1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

Categories

Copyright © www.kifomanual.com 2014-2026