Kia Forte: Adjustment
| Transaxle Control Module(TCM) Learning |
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement
|
| • |
TCM replacement
|
| • |
TCM upgrading
|
| TCM learning procedure |
| 1. |
Automatic Transaxle Fluid (ATF) temperature: 40~100°C (104~212°F)
|
| 2. |
Static learning
Repeat the below shift pattern four times or more with stepping
on the brake.
|
| 3. |
Driving learning
Drive the vehicle from a stop in D through all gears 1st, 2nd,
3rd, 4th, 5th and 6th gear while holding the throttle steady at the
specified Throttle Position Sensor (TPS) value (15~25%).
|
Control System Composition
Fault Diagnosis
Features a fail-safe mechanism that provides "limp-home" 4th gear hold
to enable the vehicle to be driven to the owner's home or dealer shop.
Fail-Safe: ...
Circuit Diagram
...
See also:
Manifold Absolute Pressure Sensor (MAPS) Installation
•
Install the component with the specified torques.
•
...
Piston and Connecting Rod Inspection
Connecting Rod
1.
Check the connecting rod side clearance.
Using a feeler gauge, measure the end play while moving the connecting
rod back and forth.
...
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Copyright © www.kifomanual.com 2014-2025