1. |
Loosen the windshield wiper arm nut (B) after removing a wiper
cap (A).
|
2. |
Remove the windshield wiper arm and blade.
|
3. |
If necessary, release the wiper blade fixing clip by pulling up
and remove the wiper blade from the inside radius of wiper arm.
|
4. |
Disconnect the washer hose (A) connected to cowl top cover.
|
5. |
Remove the weather strip and the cowl top cover (A) after removing
4 retainers.
|
6. |
Disconnect the wiper motor connector from the wiper motor & linkage
assembly.
|
7. |
Remove the windshield wiper motor and linkage assembly (A) after
removing 2 bolts.
|
8. |
Disconnect the connector (A) from the wiper motor.
|
9. |
Hold the wiper motor crank arm and remove the upper linkage (A)
from the wiper motor crank arm.
|
10. |
Remove the lower linkage (A) from the wiper motor crank arm.
|
11. |
Remove the crank arm (A) after loosening the mounting nut.
|
12. |
Remove the wiper motor (A) with 3 bolts.
|
Rearview camera
The rear view camera will activate with the ignition switch on and the shift
lever in the R (Reverse) position.
Note- during initial start up, system may not display instantly due to the audio
...
Accelerator Position Sensor (APS) Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
Front Strut Assembly Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...