Kia Forte: Installation - Manual Transaxle - Manual Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle / Installation

  
If the oil seal on the transaxle case side is damaged and fluid is leaking, replace the oil seal with a new unit. When installing the new oil seal, use the specialized tool (oil seal installer, 09453-2F300).

1.
Install in the reverse order of removal.
2.
Adding manual transaxle fluid after Installing the manual transaxle.
(Refer to Manual Transaxle System - "Manual Transaxle Fluid")
Removal
1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray ...

Back-up Lamp Switch
...

See also:

Heated Oxygen Sensor (HO2S) Removal
[SULEV] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the connector (A), and th ...

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

Component Location
1. Sunroof 2. Sunroof switch 3. Sunroof motor & controller ...

Copyright © www.kifomanual.com 2014-2023