Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Brake Booster / Installation

1.

Install in the reverse order of removal.

A.	Before installing the pin, apply the grease to the joint pin.

B.	Use a new snap pin whenever installing.

2.	After installing, bleed the brake system. (Refer to Brake system bleeding)

3.	After be equipped perform bleeding air procedure in clutch release cylinder after pouring the brake fluid. [MT only] (Refer to Clutch - "Clutch Release Cylinder")

Inspection

1. Inspect the check valve in the vacuum hose. Do not remove the check va ...

Vacuum Pump

Components 1. Vacuum pump 2. Bracket 3. Lead wire assembly ...

See also:

Tire and wheels
Tire care For proper maintenance, safety, and maximum fuel economy, you must always maintain recommended tire inflation pressures and stay within the load limits and weight distribution recommended ...

Troubleshooting
Problem Possible cause Solution Not pairing Bluetooth device of Car is not discoverable mode Enter Bluetooth pairing (searching) mode Userâ ...

Water pump Inspection
1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. 2. Check the bearing for damage, abnorm ...

Categories

Copyright © www.kifomanual.com 2014-2026