Kia Forte: Intake Actuator Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Intake Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the glove box housing.
(Refer to Body -"Glove Box Housing")
|
| 3. |
Disconnect the connector (A) and then remove the intake actuator
(B) after loosening the mounting screws.
|
| 4. |
Install in the reverse order of removal.
|
Intake Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuato ...
Controller
...
See also:
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross V ...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the battery (A) and ECM (B).
...
Troubleshooting
Symptom
Suspect Area
Remedy (Refer to page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drai ...
Copyright © www.kifomanual.com 2014-2024